Don Kelly
Don Kelly
Is SBAS (WAAS) decoding enabled in GNSS-SDR? I'd like to use both GPS and SBAS L1 corrections for PVT, but not seeing if it's been added to GNSS-SDR. Thanks much!...
Carles, In your earlier posts (#386, #410) you mention that you've been able to run two rtlsdr successfully. I'm trying to get two clock-synched HackRFs running starting with an edited...
Here's a brief article on some things to look for in a "good" GNSS signal. I give examples of what a clean, fairly strong signal looks like, contrasted to a...
Attached is a short memo on setting up the BladeRF 2.0 Micro RF front end for GNSS-SDR. I ran into a number of issues, so perhaps this would be helpful...
For anyone interested, here's how I ran a GPS simulator (bladeGPS) and fed the signal in real-time to GNSS-SDR. bladeGPS is based upon the open source gps-sdr-sim code, and there...
There have been a few other posts from users who have used the gps-sdr-sim software to generate raw GPS signals, store them to a file, then process that file in...
I'm trying to run the bladeRF-fsk, and I'm getting the following error: Failed to set TX VGA1 gain: Operation not supported Looks like a cool demo. I'm guessing bladeRF-fsk may...
Setup: MacOS 12.2.1 Monterey, Matlab R2021b I've followed the steps under 'help bladeRF.build_thunk' but am getting errors. A "libbladeRF_thunk_maci64.dylib" gets produced, but when I try to run the bladeRF_rx_gui.m demo,...
I get to the second step of the install, and get the following error. Any suggestions? Looks to be an X11 issue, and maybe Monterey is using XQuartz instead of...
Is anyone still working on this effort? I've been experimenting with the Acquisition.py portion and it works very well. Would be neat to keep building out tracking and nav. I'm...