Michael Gregorius

The SDL input feature seems to be fairly new. I have just checked and LMMS 1.2.2 does not have it. Are you sure that it does not happen with a...

Thanks for checking @JohannesLorenz! Regarding your observations: > 1. You can change the outputs, but it only has an effect after restarting. This also reflects what your code is doing:...

@JohannesLorenz: I have merged the changes of the now closed PR #7920 into this PR. The rationale is that the SDL driver dialog already sports input selection as well although...

Moving some of the discussion here so that we are not confined to that small code review discussion. > Sorry, I cannot follow. Might be the heat :) Tracks end...

@bratpeki, do you want to test this?

> Sure! I run PW, not native Jack, is that sufficient? Great! :slightly_smiling_face: I run PipeWire as well and I think it should be sufficient. Please note that the recording...

@bratpeki, if you want to test the feature in the full context of recording then you can follow the steps described here: https://github.com/LMMS/lmms/pull/7786#issuecomment-2993428205.

> Okay, ran it now. I feel like setting both the L and R is a bit overkill. Also, most input devices will be microphones, which are mono. The mono...

> The pin connector from #7459 might be a good fit for selecting JACK outputs and routing to them, though if we wanted to try that, it could probably be...

> Okay, I'm back! Thanks for testing, @bratpeki! > Tested again, works flawlessly! AFAIC, this can be merged immediately, maybe minus the debug messages on the terminal, but then again,...