operating-system

operating-system copied to clipboard

Unable to upgrade to 13.2

3

### Describe the issue you are experiencing Clicking the Install link yields the following in the Supervisor log 2024-10-16 20:48:25.295 ERROR (MainThread) [supervisor.os.manager] Home Assistant Operating System update failed with:...

jfmoots

Restarting HA from webpage causes VMbox to crash

5

### Describe the issue you are experiencing I had Home Assistant working OK on my laptop as a test to see if I would get into using it. All went...

MichaelMTB

Boot Loop Failure - Can't set block device, no valid slot found

1

### Describe the issue you are experiencing After an AC power loss my home assistant installation will not boot. It boot loops with the following information and goes so fast...

Gelob

ath11k/ath12k firmware missing, CONFIG_IRQ_REMAP not defined either

3

### Describe the issue you are experiencing I've attempted to add the firmware for ath11k and ath12k (to support my 17cb:1107 WiFi 7 card) to `/mnt/data/supervisor/firmware` and reboot but I'm...

OdinVex

RFC: Add Makefile variable for Supervisor channel

2

Allow to set the release channel pre-installed Home Assistant components like Supervisor and add-on are fetched from. This channel is then also used at runtime. ## Summary by CodeRabbit -...

agners

Error updating Home Assistant Operating System: Cannot connect to host github.com:443

2

### Describe the issue you are experiencing In short – Home Assistant lists an available update, but I cannot install it – it says it cannot connect to GitHub. Running...

p-mitana

Flooded by error ➜ eth0: not whole frame pointed by descriptor

2

### Describe the issue you are experiencing ### The problem Since I am on `2024.8.x`, I am seeing my ha CLI screen being flooded with error message that looks like...

shamasis

### Describe the issue you are experiencing I've installed a fresh copy after some failure and getting each time the same thing that I've not experienced in the past when...

lebinho

### Describe the issue you are experiencing i think i found a bug or at the very least non-ideal-behavior from haos. i tried restoring from backup on a brand new...

bharvey88

### Describe the issue you are experiencing Hi, i'm currently playing around with the [ollama addon](https://github.com/SirUli/homeassistant-ollama-addon) and running gemma2:27b on my home assistant computer. So far it works without any...

VenominousX