Manuel

Can you enroll with the libfprintd by itself like with the commands ?

What is the compile error ? Did you try the package in AUR ? -> This does also not work with a kernel 4.9.11 for the moment.

There you go: https://youtu.be/dKV7vusrJ4g Hope it helps Any ideas ? Thanks! EDIT: It seems only the small movements at first are affected so its the resistance at start that make...

Hi revarbat, Nice to see you back! I'm building this snappy for a school cooperation and it would be super if we could get to the bottom of this :-)...

Hi Yes i have a similar experience. When i use marlin to move the axis it is very smooth without vibration i believe. But when i print gcode there is...

Ok 80 mm/sec x accel and lithium grease on the rails seem to have nearly fixed the issue for me. I think i will go down to 70 mm/sec to...

Ok so now im printing with 65 mm/sec x axis acceleration and the vibrations are still there but only visible if you look directly for them. So the issue remains...

Hi @revarbat Ok i have more info on this issue: 1. I mitigated the vibrations as i wrote above by reducing the a axis acceleration down to 60mm/s (from 400)...

Hi guys, Just to chip in; I tried graphite based lubricant on the X axis and it helped but not so much that I could actually print with the snappy....

Hi I think that are harmless warnings, i had them to but the part was renderd and did slice fine with Prusa Slicer. However the slicer repaired some stuff but...