Manuel

> Brief update post-Mk3S release. The R4/Mk3S parts still have the same 4.00mm motor shaft/bondtech drive gear to printed part filament path spacing as the R3 and previous parts. I...

I have this also but not with sleep but with reboots. If i boot into the bios and then into mac i get this.

Hi @Andrew-Hello and @Menchen I tested my settings for a few days and they work on m i5 I wanted to make the settings permanent like in your reference command:...

@stevezhengshiqi That is wonderful news! I tried to use the Realtekcardreader and RealteckcardreaderFriend. I put both kext into the OC/Kext folder and set the values in the plist to true....

@stevezhengshiqi I used the latest (1.59) as base and replaced the Lilu kext with the new one (did not enable this in plist, figured it should be enabled anyway) I...

Hi @0xFireWolf and @stevezhengshiqi i tested the new release and the sd card reader works in a short test. That is very cool! However after like a few minutes after...

> @ManuGithubSteam One tips for your vm setup, folder sharing is built-in VMware so you won't need `sshfs` and avoid ip/ssh password problem. I did not want use folder shareing...

@Menchen Thanks for replying these are valid points.. > @ManuGithubSteam > > > I did not want use folder shareing as in Linux it is just a folder (not sure...

> Duplication of #36 #36 did not get it to work as far as i read. Is that correct ?

Unfortunately im not a programmer... Thanks for letting me know. I will keep working in this so far till there is a better solution. Please test and give feedback :-)