zxd00276

> Ok. I'll fix that. > > Do you see the telemetry in the transmitter? Yes, I get the telemetry from transmitter. This test was done with genuine Hitec parts....

> Added wire colors identification with [commit](https://github.com/dgatf/msrc/commit/2a7a276d9aa52f3a786ef0e141476736ed4c9701). Please let me know if it works with MSRC. MSRC is not currently working properly with the Hitec system. Debug is attached. Hitec...

Mr. Daniel GA, A test was conducted. The receiver is powered by the BEC power from the ESC. The PULL UP power source is the R2040's 3.3V power supply. The...

I am attaching the data of the I2 signal of the genuine Hitec temperature sensor. Since the 2nd and 8th bytes of the 8 bytes of the oscilloscope data change,...

When I set your Arduino Mega as a virtual receiver, if I turn on the RP2040 first and then the Arduino Mega, the LED inside the RP2040 will blink. At...

Mr. Daniel Ga; I use 1kohm　resistor for the pull up . Best regards, Gorochan ----- 元のメッセージ ----- From: "DanielGeA" ***@***.***> 宛先: "dgatf/msrc" ***@***.***> Cc: "zxd00276" ***@***.***>, "Author" ***@***.***> 送信済み:...

Mr. Daniel GA, Please refer to the attached files of my RCGROUPS report #593. It is Pulseview data. The first address read 08 is displayed in the file. DIY -...

> Does it works if you plug the genuine sensor after the receiver boots? Yes, telemetry data transmit to the transmitter.

> This is what I get fron arduino mega when rp2040 is not connected: > >  > > I expect to see the same from the hitec receiver when...

> This is what I get fron arduino mega when rp2040 is not connected: > >  > > I expect to see the same from the hitec receiver when...