Peter Siebler

# Device ``` Chip is ESP32-D0WDQ6 (revision v1.0) Features: WiFi, BT, Dual Core, 240MHz, VRef calibration in efuse, Coding Scheme None Crystal is 40MHz Auto-detected Flash size: 4MB ``` ##...

It won't be so easy with a cast-iron cover, because it significantly weakens the signal. There are only 2 options for this: - With the ESP32 as close as possible...

Same Problem here: ``` { "battery": 100, "humidity": 71.88, "last_seen": "2023-09-09T10:26:53+02:00", "linkquality": 255, "report_delay": 5, "temperature": 23.19, "voltage": 3000, "device": { "applicationVersion": 5, "dateCode": "20201026", "friendlyName": "weather-SNZB02-02", "hardwareVersion": 1, "ieeeAddr":...

@cococheaf Also located in Höchst. Where did you buy the MBus level converter?

Hi > @zibous I'm located in Luschnou ;) .. Have a m-bus slave click from mikroe left over, if you need one :) Super, würde den nehmen - wie kann...

@alandtse Thanks, now a fresh installation Homeassistant (latest) on Docker, no other components only alexa_media. Used amazon.de, 2fa enabled. Same as in my production Homeassistant. Can't switch on/off any Alexa...

Please find in YAML line external_components, and modyfi it to: - source: github://SzczepanLeon/[email protected]

> Error: Check connection to CC1101! It means that ESP can't connect to CC1101. Version for the current yaml > source: github://SzczepanLeon/[email protected] Do not work, Version 4.0, Szczepan Leon has...

> Is there an easy way to test if I maybe damaged the CC1101 when soldering the antenna and cables? Negativ, but wmbus component will check this, and reporting an...

Hi, I don't have good experiences with the updates of ESPHome, they change too much and make everything unstable. Therefore I use the Docker variant and stay on the version...