zhangquanyi

Does manually adding G28 at the end of the file solve this problem?

> I have also experienced this. So it is either that this is an issue with the controller as based on your advice for him to contact sales, or it...

>  > > here is a pic. If the calibration data is detected to be reset, this pop-up window will appear on the screen, is this phenomenon after doing...

I'm very sorry for not replying to you in time. thank you for the log file. purifier is not connected, the screen tries to get the module status of the...

Hi nonno-cicala, Thank you very much for your feedback! If the offset is not correct it should be fixed by homing and setting the origin.