尤晓杰

vpn 对于我就是一个加速的通道， 源地址就是希望不变，这样我在外面才能直接访问到，服务器与nas一体，好不容易ipv6 能绕开nat 直接点对点访问。源地址泄露不重要，反正看的都是技术问题。

我在想 wg 2001:470:xxxx, 本机 240e:xxxx,不是一个网段，所以是不是需要ip6table 做转发？或者ip rule？没有头绪。ip6table的转发和ip table的路由条目啥关系啊。有些迷糊。 打过标签的包： 1. ip6table 是不是只能端口转发? 能转发至某个网卡？ 2. ip rule 是不是可以打标签的包默认网关是wg？但是两个不在同一个网段，所以糊涂。 3.对了 是不是可以ip6 table 直接更改源地址? 但是这貌似只能在pc终端发起端实现。中间路由器端实现没法获得发起pc的ipv6地址。 3. 我现在配置的是路由器同时下发 2001:470 和 240e:xxxx 的地址前缀，终端同时存在两个不同网段的ipv6 查了下 ，ipv6...

the same question!

I get pci-pre-cal*.bin from netgear art , but it runs only in sta mode, why?

> You need SDL1, not SDL2. thanx, but still segment fault. ``` sys0 = tsunami { memory.bits = 28; rom.srm = "rom/cl67srmrom.exe"; rom.decompressed = "rom/decompressed.rom"; rom.flash = "rom/flash.rom"; rom.dpr =...

debian?

``` *************************************** * U-Boot 1.1.4--clean * * Build: 2020-07-03 * *************************************** ** Warning: bad env CRC, using default, use 'saveenv' to save it in FLASH BOARD: TP-Link Archer C7 v1...

> PCIe: PCIe slot 0, PCIe slot 1 great work! better than original tplink uboot!! It works in my chinese version of wdr7500 ver3.0 I mod it to 16MB w25q128,...

yes openwrt, is the web firmware recovery function (you added) affected? and if i put art to the last 64kB at the end of 16MiB does openwrt uboot recognize it?

> @uis246 I know it's not good to create a fork or something, but there is no proper base for bootloaders for routers. That's why most are based on an...