yammaster

I had this issue too. You can manually install the packages by: sudo apt install python3-pandas for all in requirements.txt on my other printer I had to do: sudo apt-get...

`*************************** START **************************** START TIME: 202206222156 CONNECT BAUD: 115200 set state: ESP_DL_SYNC serial port opened ----------- baud:115200 root baud:115200 ------------- ===============BAUD : 115200===============CALL DEVICE SYNC connecting... chip sync ok mac...

And this is the result with the esphome-flasher: `ets Jun 8 2016 00:22:57 rst:0x1 (POWERON_RESET),boot:0x13 (SPI_FAST_FLASH_BOOT) configsip: 0, SPIWP:0xee clk_drv:0x00,q_drv:0x00,d_drv:0x00,cs0_drv:0x00,hd_drv:0x00,wp_drv:0x00 mode:DIO, clock div:2 load:0x3fff0018,len:4 load:0x3fff001c,len:1044 load:0x40078000,len:8896 load:0x40080400,len:5828 entry 0x400806ac I...

The board was powerd by the pc. I used another board, flashed with the new firmware and it looks like better in my opinion: `ets Jun 8 2016 00:22:57 rst:0x1...

yes I tooked the latest

YES it works now, I see the channels from the BLE in my TX! It runs with the other board. The first one boots always twice with the brown message....

I've to reconnect after power off - is it right?I've to discover. In model setup the connected field is empty. If the PARA modul is connected, still there is the...

I used the ESPHome-Flasher as the only one flasher for the second board. It could be better when you are changing the Wiki, for easy to use and minimize mistakes.

Hi @all, maybe I had a similar problem with my Elcrow 7" which works in low resolution mode fine but not in 1024x600. First I tried to modify the extrargs...

The boot screen hasn't clear fonts - but it doesn't matter for KlipperScreen: