y8s

I'll stay tuned. Thank you Henrik.

Is there a list of parameters for the neopix command? Would the rpi-gpio nodes conflict if there was nothing configured on the pins I'm using for neopix? (I will double...

I had to dig into the python to answer the first question, but your command did light up the strip. I also checked that python was not using pin 12...

> You should not need to run the command yourself (except to check it does run) - the node should call it - that is what sets up the OK...

I run everything as my user (pi) without sudo. so I checked the systemd status and it shows ``` pam_unix(sudo:auth): conversation failed pam_unix(sudo:auth): auth could not identify password for [pi]...

Different sensor modes on the pi camera have different crop factors. See this documentation: https://picamera.readthedocs.io/en/release-1.13/fov.html#sensor-modes

I am not running exactly this setup but something similar. I noticed my docker instance kept crashing and restarting because it was no longer detecting the Coral USB device. I...

Quesiton about implementing this after the fact: How do you reconfigure Gravity Sync if it's already installed and you want to add a third pi? is it as simple as...

> > Quesiton about implementing this after the fact: How do you reconfigure Gravity Sync if it's already installed and you want to add a third pi? is it as...

I did some testing and the primary is "disabled" with the secondaries "auto" and it does what it's supposed to. Auto is fast enough but I might play around with...