xsp1989

> Thanks but after switching IO config to Zigbee TX/RX I got the same outcome....invalid signature :( El mar, 28 may 2024 a las 9:53, xsp1989 ***@***.***>) escribió: > […](#)...

> > As I understand, you need to have upgraded to at least EmberZNet 7.4.x firmware version or later to use the new ”ember” driver/adapter in Zigbee2MQTT, but from what...

> Which is the latest working EZSP firmware for Tasmota then? Currently using your 14.0.0 build and 6.7.10 Tasmota only supports EZSP V8. The latest version available is 6.10.9. You...

> > Since not all dongles have buttons > > This is a problem, there is no way out of router firmware once flashed, as need hardware bootloader reset to...

@Hedda I have not done any development other than NCP/RCP on the latest SDK. If you use the 6.x version of the SDK to develop routing firmware, it is actually...

What I mean is that if you make a routing firmware that is exactly the same as the firmware I provided, it may require additional development, but if you only...

@darkxst Can you provide your version of the firmware that has a lot of CRC errors? I will also conduct corresponding tests. I built a firmware based on 7.4.5, using...

I want to know what is the concept of low resource hardware. ZB-GW04 uses the same chip as Sonoff ZBDongle-E (V2 model) and SMLIGHT SLZB-07, which are both efr32mg21a020f768im32. Why...

> @xsp1989 do all versions have the mg21? We've seen in the past that it also shipped with older chips and it is quite hard to determine which one you...

> Correct, I do not recommend this dongle, particularly if users are purchasing new hardware, they should look elsewhere. Even though it uses the same MG21 chip as others, It...