xjols

> The `classic` discriminator used by default below 800M is not very good for GFSK, try using `-Y minmax` Yes, I assumed `-Y minmax` and the results are the above....

> Unfortunately, at 169.44 MHz, this is the `Mode N` not implemented in rtl_433. > > extract of [m_bus.c](https://github.com/merbanan/rtl_433/blob/2c1967f4f746fa058dbf1efb2de27f5b6b65e9cb/src/devices/m_bus.c#L1252) > Mode N is less than 50khz bandwidth, so sample rate...

> There is `-Y filter=num` to set the low-pass filtering. The filter helps to receiver the packets and decoded now! Where I can find all the options of RTL_433? The...

> > finally, i changed the password in the hon app. after this the integration is working. now i can check the device settings > > Do you have special...

Hello! Which hardware and software are you using to read 169MHz telegrams and decode this ? I'm also trying to decode water meter in this frequency without any output telegram...

Reading the description it seems that the led is in "Rapid blinking" mode. But the interface is working well, connected to my home wifi, and no Access Point is generated...