Jermaul

I have been on the tinker firmware for a while. Was one 16.12.1 last monday. Upgraded to the 17.10.1 tuesday. (Jan 9th). Clear eeprom Did a few prints without problems...

Same problem. Ultimaker 2 extended, converted to dual Upgraded because of the scrollsable filenames. Running 16.12 print a file just fine. Uploaded the 17.10 try to print the sams file...

Same files. Just different firmware. No T1 codes for my single color prints. And yes both extruder have pla and it is setup under material for each extruder. Not sure...

Yes off sd card. Thats the only way i print

Sorry about the late reply. dropbox to gcode https://www.dropbox.com/s/7u2y8ghmcwcj1mr/UM2EX_bioshock_eve.gcode?dl=0 but it happen will all gcodes that i printed just fine on the 16 firmware

Has thos problem been fix in an firmware? I believe i am on 16.12

I have them loaded to the materials.txt but every time i import them and power off there lost. Have to import them back every time before i turn on the...