x893

Hi, first result about 1.0.2 version (0.0.5 later, need rebuild driver) esp32 stop after scan command ## 1. Log from esp32 ets Jun 8 2016 00:22:57 rst:0x10 (RTCWDT_RTC_RESET),boot:0x3f (SPI_FAST_FLASH_BOOT) configsip:...

Thanks for resplay. I reduce SDIO frequency to 5 MHz in DTS. Reduce wires to 5 cm. With long wires and sdio frequency > 5 (10, 15, ...) no espsta0...

I can check FG version later. Don't use reset pin (need a time to add). Host: Zynq XC7Z010 with sdio connection. Linux 5.15.67 If you have a time then i...

No problem. We can test after 24th. I'm in GMT+3

Hello again, i check on other board and i have some progress now. 1. Log from host ## insmod esp32-hosted.ko esp_probe: ESP network device detected Received ESP bootup event EVENT:...

With WPA2 also not complete espsta0: SME: Trying to authenticate with 36:ce:ef:af:ca:0c (SSIDesp_cfg80211_authenticate='iPhone' freq=2462 MHz) Authentication request: 36:ce:ef:af:ca:0c 11 0 0 0 espsta0: Trying to associate with 36:ce:ef:af:ca:0c (SSID='iPhoneesp_cfg80211_associate Dima'...

First with open wifi AP, seconds with WPA2 Host always Zynq XC7Z010 Firmware 1.02 Release (from site). I need change to wpa_sup... in background. I can prepare my changes for...

Yes, disable bluetooth (esp_bt) and add contions for CONFIG_SUPPORT_ESP_SERIAL as in esp-iot-bridge (aka esp-gateway) I prepare pull later. Thanks for your help

Hi, i change init.d scripts to start wpa-sup... at startup. Also i connect RESET line to ESP32 and need increase esp_reset() msleep( ... ) now learn hostapd with esp32 hosted....

Hello, i try all instruction to flash M1sDock but all without success.  I try both COM ports, with and without BOOT+RST d0fw.bin if lvgl_example May be you can help...