wrwindsor

samwiseg0/LRS PSU Screw Terminal Cover (24v) needs a trim

1

The 24v cover is too thick on the end tabs. One side was pushing the trim pot over and the other side wouldn't fit between the bus bar and the...

Mains inlet wiring on p236 is backwards

5

If you're looking into the plug end of the mains inlet wiring, ground tang up, "neutral" is on the left and "line" is on the right. see: https://www.electronics2000.co.uk/pin-out/iec.php (IEC 63020...

mini12864 hinge piece is an accent piece per the [a] in the STL filename. It should get a Voron heart in the manual (Page 274).

"... skip the wire cover and follow the instructions on page 174." Should be: "... skip the wire cover and follow the instructions on page 190."

BOM is missing "Foam Tape" entries, both 1mm and 3mm

1

Manual shows and specifies Foam Tape 1mm (back and top panels) and 3mm (side panels) Not in the BOM. I admit that this is a minor nit, but I can't...