wollew

I am almost 100% positive that I hadn't selected "Start print job" but uploading did not work anyway. Currently the printer is on (and printing), I'll try again once it's...

Ok, I tried again, "Start print job" was definitely not selected, this was the result:  (don't get confused by the "octoprint" host name, no octoprint running there.)

I tried the branch, but uploading still fails: ``` Uploading to Moonraker at http://octoprint.at.home:7125/ was not successful. The status of the printer is 'error'. mcu 'mcu': Unable to connect Once...

> Do you use the upload dialog or the "fire & forget" mode? I am using the upload dialog, "Start print job" is unchecked.

Sorry for taking a little bit longer, this morning I tried again, interesting enough I got a different error message: ``` Uploading to Moonraker at http://octoprint.at.home:7125/ was not successful. NetworkError.ServiceUnavailableError...

It also seems that the Seplos provides only limited information via can bus, no single cell voltages for example. They're available on RS485 though.

Check out the [documentation](https://louisvdw.github.io/dbus-serialbattery/general/supported-bms/), it is supported for quite a while now.

Unfortunately this does not work for me, /printer/info returns 503 if the printer is not turned on and so we end up in the else branch in `_checkPrinterStatus`. I can...

> > Uploading to Moonraker at http://octoprint.at.home:7125/ was not successful. > > NetworkError.ServiceUnavailableError - Error transferring http://octoprint.at.home:7125/printer/info - server replied: Klippy Host not connected > > It fails because the...

LGTM, will confirm once my currently running print is done. Thank you.