wilson-wsn

Hello simone1999. Install your fork on the Arduino ide. ARDUINO 1.8.12 2020.02.13 The ESP8266MeshHelloWorld example compiles on this platform. However in NodeMcu where I'm recording, it locks up, goes into...

I have 22 NodeMcu units at my disposal. I can test on everyone.

I just tested on 5 units, all new. the problem persists. To test the units, I used examples from the painlessMesh-master library. in this case the examples work. Therefore, NodeMcu...

I was trying to find the problem, and I realized that when we compiled the code without the mesh.begin () statement; Compilation happens and NodeMcu does not freeze. possibly the...

Exactly, when starting the mesh network, NodeMcu freezes

Hello everyone, I can compile the code on the Arduino IDE. But after recording the sketch, NodeMcu is stuck. The messages on the serial port are: * ets Jan 8...

I tried to compile, but there are errors. how can i fix? the error messages are: Arduino: 1.8.19 (Linux), Placa:"NodeMCU 1.0 (ESP-12E Module), 80 MHz, Flash, Disabled (new aborts on...