whale-av

Results 7 comments of whale-av

[Feature Request] Nuki-hub Stand Alone mode - have GPIO working when not connected to a network

Thank you for your reply. Could it be my fault... because I filled in the information for an MQTT broker address? Here is my config file.... in case it is...

[Feature Request] Nuki-hub Stand Alone mode - have GPIO working when not connected to a network

Thank you. I don't know what "general input/output means". My use is just to send a BLE command to open Nuki lock when GPIO 14 is grounded. I cannot recheck...

[Feature Request] Nuki-hub Stand Alone mode - have GPIO working when not connected to a network

Nuki-hub version 9.0 Installed using web tool. I don't have access at the moment..... I remember GPIO 14 (I have added an additional pull-up circuit) Input: Unlock: When connect to...

[Feature Request] Nuki-hub Stand Alone mode - have GPIO working when not connected to a network

Thank you. I will do that, but it will be more than a week before I return home. David.

[Feature Request] Nuki-hub Stand Alone mode - have GPIO working when not connected to a network

I have brought the lock and esp32 home so that I can test. The nuki hub is updated to 9.01. I have reduced the configuration as far as possible, but...

[Feature Request] Nuki-hub Stand Alone mode - have GPIO working when not connected to a network

Thank you. I updated to 9.02 and did see the advanced menu, but did not see the "Disable network if no connection within 60 seconds" entry. The main page still...

[Feature Request] Nuki-hub Stand Alone mode - have GPIO working when not connected to a network

I have OTA'd to 9.02 Beta3 Updater build: 11693590688.16.1 and ticked the "Disable network if no connection within 60 seconds" box in the /advanced menu. After a reboot GPIO does...