CC3D-CableCam-Controller
CC3D-CableCam-Controller copied to clipboard
wernerdaehn
CC3D and STM Cube based CableCam controller
It does not get any changed values from the SBus and no idea why. Related to DISABLE_RC maybe? Can't find the spot.
During some test on the rope, I found a little problem with deceleration near to the end points. I see this in autoplay, but it is the same if you...
Hello. I want to build this project, but if i type $w in putty to save the settings, putty says "eeprom save failed". what should i do? i use this...
Hi, I'm using cc3d mini revolution from hobbyking I have spektrum dx8 and I'm using ppm encoder. I can't get any input signal from receiver. with $i command all values...
Status update: I can read and control the odrive's velocity mode now. Similar to the VESC. Need some more testing but then I can release the new build.
hello, i m not an exper in rc model and programation. my configuration -lrp 1600kv -skyrc toro 150 amp -radio fly sky fs-th9x -recever fs-r9b (8 channel) pwm whis an...
Is it possible to use buzzer outputs of the flip board as the confirmation of setting the endpoints? One beep for the first and two beeps for the second endpoint?...
Can you please keep an eye on the position sensor? In my case I marked one magnet of the sensor wheel with a pen and hence know the exact position....