Stefan Wagner

Looks cooool! D1 (on your schematic) limits the voltage on the positive input of the opamp to around 0.6V (forward voltage of the diode). If the soldering tip is powered,...

TaaraLabs and some other users made their own versions with P-FETs. This is now supported by the software. But I don't have a version with P-channel MOSFET myself.

I suspect they have the same pinout. Nevertheless, to be on the safe side, you should check it with the multimeter. The earth pin should be conductive with the soldering...

Hi, I don't know why the LEDs don't work on your first boards. It cannot actually be due to the EEPROM. I rather suspect that the LEDs are defective, in...

Nice, I'll put the link on the main page.

Yes, the display should show something. Are all connections correct, has the correct display been used, does it work with other programs?

Hi, yes, that is basically a good idea. However, I'm busy with a number of other projects at the moment, so I won't be able to get to it any...

Sorry, I'm not familiar with the c210 tips.

Looks very similar to the T12 tips, except for the TC, but that's not used anyway. There is obviously no tilt switch. I would say try it out.

I'm not sure since I only have a 1541.