Vassilis Bourdakis

+1 please, my 304Ah@24V lifepo4 bank stored at circa 30% for a couple of months (while testing various controller comms and settings and waiting for the shunt chips to arrive)...

 @stuartpittaway after storing the bank for a week or so at 48% SoC, recharging it slowly for the last couple of days to reach 100% SoC this afternoon (via...

had similar problems with the screen, turned out the diode was soldered slightly high and was fouling (shorting) on the sdcard, draining the powersupply and rebooting the board. explained in...

@bertvaneyken check what I and others posted in #220: https://github.com/stuartpittaway/diyBMSv4ESP32/issues/220#issuecomment-1639707646 update multiplus II firmware to latest and check again V.

> please let us know how it's going!

well, surely makes sense, was thinking how to disable and re-enable the bank according to needs/consumption/weather in an automated fashion. Actually main task of the relays would be to get...

yep, hence me keeping in parallel the Trojan T105RE bank already onboard so when I disconnect, I wont burn the diodes as the other bank is always there to take...

two issues (I can roughly think of atm but it's a hard and long day...) A. the 4 in/out pins could be used to "monitor" contactor condition (yellow wire on...

not quite though, cannot assign RE2 activated when no rule triggered is true! And on a pulse, once. How? So, bank V over triggered, have RE1 activated (orange cable on...

thought about it, unless I understand the code and do a mix match of reading an input for current state of contactor + checking rules and pulsing ONCE either RE1...