Uwe Santos

getting the same problem here does pasting in the pins work?


PnP, partslist and schematic have all different values to the readme for the v2.0 2020rx

+1 Tried flashing it but it only shows 3 UART and exhibits strange behaviour i'm guessing i got the wrong target.

I'll attempt to make a target, but I've never done it for iNAV/betaflight or anything. I've done it for 3D printer boards using STM32 so I'll give it a shot....

> I managed to modify the target BETAFLIGHT_F4 (src / main / target / BETAFLIGHTF4 / target.h) for iFlight SucceX-E F4 V2.1 > > Yesterday I took off on a...

Is it showing up as red or is it greyed out?

Have you tried a full power off. Mine was red when I connected to usb first. Disconnect usb and power. Then connect battery after that plug in the usb to...

The target is used to create the hex file. Please be careful flashing verify it works first.

> > > I managed to modify the target BETAFLIGHT_F4 (src / main / target / BETAFLIGHTF4 / target.h) for iFlight SucceX-E F4 V2.1 > > > Yesterday I took...