turnali

> @turnali Do you have a 12VDC bed to hook up to the SKR pro just to see if the board can heat a 12V bed?? Maybe you have a...

> > > @turnali Do you have a 12VDC bed to hook up to the SKR pro just to see if the board can heat a 12V bed?? Maybe you...

> @turnali Did you wire the CLK pin to GND pin on your TMC5160 driver boards?? Here is a .pdf that shows the driver configuration for the SKR Pro board...

> > > @turnali Did you wire the CLK pin to GND pin on your TMC5160 driver boards?? Here is a .pdf that shows the driver configuration for the SKR...

> I'm not sure if this was answered above for you guys but there needs to be 12-volt or 24-volt power from your power supply going to each of the...

I am using MKS MINI12864 V3 because of the klipper firmware. After I flash the klipper firmware, the board never connects to the raspberry pi. And after I flash the...

By the way, I also tried BTT TFT35 V3 display but still no luck

I will try it and let you know if it works or not. But this is a brand new board that I just bought. Its not normal that the SD...

Can it be a faulty board?

> I bought Mks Monster8 board and ts_35 display from Aliexpress store a few days ago. First, I configured the marlin firmware with a ts_35 display, uploaded the firmware to...