Tobias Stöger comments

Repositories
Issues
Comments

Results 4 comments of


Tobias Stöger

The current MK3S extruder body is 0.4 mm loose(r)

Still no comment or recommendation from Prusa yet?

Question schematic

D6 (STA) - called "Status PIN" - reading HIGH means, the MicroWakeupper (your connected switch) was triggered (is active) - was closed or opened - depending on your setting (NC/NO)...

Question schematic

By default the MicroWakeupper will reset (RST PIN goes LOW) your running esp and after about 2 seconds it goes back into "standby" - waiting for the next button press.

"Cut J1 to turn off Wemos completly"

Hi there, thank you for the kind words. The 2 pads are connected via a on board trace. Use a sharp knife and cut the trace between (on the board...