Gwenhael Goavec-Merou

For lattice it's true, the board is only used to know onboard cable. When no default cable you have to specify it manually and -b is useless. Seems something wrong...

> If the bitstream is alone, the flash works. But if in the same .bit I have the bitstream (gateware) + firmware, it doesn't work I have never tested to...

`spiOverJtag` seems correctly loaded and flash id is correctly read: it's a good point this mean access seems working. This model isn't into database but it seems not a problem:...

Thanks for the schematic, I have to take a look at that, but I see there is no pullup/pulldown for SPI signals: I have already sees failures due to glitches.

It's a possible reason but I have to take a closer look to the datasheet. Unfortunately I haven't this chip @home (this is available on mouser but shipping cost is...

Hi, I have tested your patch with a de0nano and observe a better xfer rate. But with an arty I'm unable to load a firmware. I suspect data loss. Tx...

I have also reduces rx to 128

I have created a new release: now this svf is no more present.

I think this issue could be closed. `test_sfl.svf` has been removed from the repository.

It's true: I suppose I have to create two variant: one for cyclone with oscillator and one for family without.