tphan26363

I did have the same problem with PT100 amp. How ever this happen to all other hardware as well since the rail voltages of all chips are not the same....

Just use the existing pin for e0. it has a pull up resistor but should not affecting the PT100 much since the board should be able to dive much more...

That does not sound right. Froze up when connect the amp to the T0 input? I think it can't froze up when connect the amp board to the T0 input....

I having the same problem. Print Ok using SD card on TFT-35. When print over USB port it's randomly stop and Octorprint report no communication. How ever I can see...

I use a very bad and long usb cable.. and now it is not stoping any more. Good and high quality cable don’t work. Short cable don’t work. Now it’s...

I can't point out what is wrong since I don't have time. But here is a configuration with mixed TMC2208 and TMC5160 with Dual Z. You can use it as...

it just an example . it can not apply to your case. But I mark all the places that need to change. you can follow that and do your own....

I don't believe that is the right chip. defined here is STM32F407ZG # # BIGTREE_SKR_PRO (STM32F407ZGT6 ARM Cortex-M4) # [env:BIGTREE_SKR_PRO] platform = [email protected] framework = arduino board = BigTree_SKR_Pro extra_scripts...

Have any one able to use advance pause with the 12864 LCD? it seem that the M108 did not work for SKR-pro so the OK button can not clear the...

It displays a lot of OK pop up with irrelevant information, during printing such as "Tool head 0! OK." I think we need some useful information to display but not...