tomtom0707

No :( It is not so easy, you probably have to modify some functions...

Maybe the following information about it. Now I have the entire system running with your ESP32-ACAN. So I use the internal CAN controller of the ESP, the hardware from the...

Hello Pierre, I have written a small program where I can switch between the two CAN controllers with the "ESP_CAN" switch. The MCP is supplied via 4MHz, PLLx10. This was...

Hello, I took the time to revisit the topic. In my opinion, things don't run smoothly when the CAN gets stressed. Hardware: MCP2518 with 4 MHz oscillator, interrupt and 20MHz...

Too bad nobody cares... :(

Hello Pierre, I had invested a lot of time and effort in troubleshooting, but got no result. I've been using an Arduino driver from Seeed for the can bus shield...