Taylor Bates ⚡

Not sure what's going on with the ACHT product, going to have to take a look into it, it's not aligned with the map at all. https://goes.freakinbananas.xyz/goes16/non-cmip/fd/acht/2019-07-25/GOES16_FD_ACHT_20190725T202044Z.jpg

It would appear that it only shows a portion of the full disk and cuts off the rest, makes the image look rather odd, but it's normal behavior: https://www.goes-r.gov/imagesContent/users/products/GOES-16-Cloud-Top-Temperature.jpg

I'll have to take a look at it, IIRC the background color is dependent on the product, some products choose the lowest value for pixels without data, while others use...

The map overlay isn't off, those products only work over a range of satellite zenith angles. Basically, the algorithm that derives those products doesn't work if the satellite is too...

Run `git pull origin master` in your cloned goestools folder to update with the latest commit, this is a duplicate of #57

There was a revision to this documentation early this year, mostly clearing up some ambiguities as well as some incorrect information: https://dcs1.noaa.gov/documents/HRIT%20DCS%20File%20Format%20Rev1.pdf

Here's an example of a transmitter used for stream gauge measurements. It seems that the data is sent from a data processing board over serial to the transmitter, allowing for...

Here's a document about some of the most common data formats I found in the DCP Data. https://www.sutron.com/wp-content/uploads/2014/01/36e86d82613460cb3b4cf364c4daf2f4.pdf

Hi Mike, Presumably it shouldn't be too difficult to implement a DAMS-NT service to push out the DCS files as part of goesproc. The HRIT/LRIT DCS format is very well...