Codimation

I am also very interested in finding out the answer to this question.

> AqualinkD turns the heater on/off/temp through the control panel. So as long as the control panel is configured correctly, it should all work. Can you turn the heater on/off...

@ncpe20012003 I am trying to figure out how to control my Jxi heater directly without an Aqualink unit. I have RS485 connected between Jxi and my System with 12v power...

> @timelery The Jxi protocol hasn't been fully worked out yet. As soon as I get some logs from the unit when it's being controlled from a control panel, I...

@sfeakes Testing again I get a lot more back from the Jxi unit. Thoughts? 

I think a really good first step would be figuring out how to send a message to the Jxi heater to set it to "JANDY REMOTE ONLINE" 

I created a console application that can be used to send remote control commands to Samsung TVs that are using the new encrypted communication protocol. Model 2014+ Samsung TVs. Run...

The protocol is indeed encrypted and impossible to decompile. It was built with c++ and wrapped in c# to be utilized by their windows application. However I did in fact...

The command line utility is here. Make sure any relevant samsung tvs are powered on and on wifi before launching the tool or else it will not find them during...

I am looking into the issue with volume up/down and mute. Stay tuned.