Tiago

I'm having the same problem. So basically is related to the distance from the magnet? I also had to switch the order of the wires. ON motor is A-B-C-D and...

> @tiagomaricate it can be the magnet distance to the board IC (2-4mm) or the magnetic surrounding of the magnet (ferromagnetic bearing right next to the shaft backside). It might...

> @tiagomaricate it can be the magnet distance to the board IC (2-4mm) or the magnetic surrounding of the magnet (ferromagnetic bearing right next to the shaft backside). It might...

> > I'm having the same problem. > > So basically is related to the distance from the magnet? > > I also had to switch the order of the...

> A starting point can be found here: [#3 (comment)](https://github.com/bigtreetech/BIGTREETECH-S42B-V1.0/issues/3#issuecomment-691197566) > A working adapter would be a stlink v2 clone, or any other stm32 programmer that can be found on...

Is it solved? Same problem here.

> @tiagomaricate after testing with many different motors I can say, that the motor design itself is a strong factor. Try using a different nema17 model without any "magnetic parts"...

How do you connected and set the pins?

> Thank you! I'm facing some difficulties due all my other pins are in use. And I believe I'm not understanding the logic behind on how it works.

@nesergen Good day! Actually both, but more related to the conections. My config is this way: PWRDET SKR (signal pin) -----> UPS board (signal pin) PWRDET SKR (signal pin) ----->...