LSteen Designs
LSteen Designs
Very Impressive!
Unfortunately it is still not working :(
No such luck. I ordered a new display that is attached to its own board and will try it using the I2C connector. One other issue I am wondering about...
*UPDATE* Display is working!! I did what I described in my last post. I also removed the pull up resistor on GPIO45 and the two on SCL and SDA as...
Ya I was hoping it would get some updates. I just started learning to code at university so I'm a little lost on software side. Looking forward to seeing what...
SOLVED. I found the correct parameters in code and am now achieving proper reflow conditions with my oven. If anyone else needs help with this ill leave it open for...
Not sure if you still need this but I ended up designing a new board with a new working display circuit for a direct connection. This is the schematic. The...
No problem good luck on your project! let me know if I can help. I went by the book with my pcb on a 4 layer board. The esp32-s2 hardware...
I have everything setup up in both hardware and software as specified in this repo. My drone is running mini_main and when turning on the drone, the red led eventually...
I have verified that the propellers are correctly installed and have ran all the test code. The gyro/accelerometer are outputting data and responding to movement and the controller is functioning...