tghi461

Hi, I have been working to try to install NetCDF-Fortran for WRF modeling needs. I believe I successfully installed NetCDF-C (did make test and it reported success). I followed all...

Thanks, here are a couple configure execution outputs (I hope these are what you are looking for): (1, when this command is used): CFLAGS="-I$(/home/tes/WRF_libs/netcdf2/bin/nc-config --includedir)" LDFLAGS="-L$(/home/tes/WRF_libs/netcdf2/bin/nc-config --libdir --libs)" ./configure --prefix=/home/tes/WRF_libs/netcdf2...

It's just a one-line report: [t.ghidey@aeolus netcdf-fortran-4.6.0]$ make check Makefile:317: *** missing separator. Stop. [t.ghidey@aeolus netcdf-fortran-4.6.0]$

Thanks again! it is still the same. I have had this repeated zillion times, as in: [t.ghidey@aeolus WRF_libs]$ rm -r netcdf-fortran-4.6.0/ [t.ghidey@aeolus WRF_libs]$ ls netcdf-fortran-4.6.0 ls: cannot access netcdf-fortran-4.6.0: No...