teachingtechYT.github.io
teachingtechYT.github.io copied to clipboard
teachingtechYT
Under flow calibration it says: "If your measurement is significantly off, the following calculator can then be used to calculate the new flow rate:" But it does not state what...
in this paragraph: Some printers may have a combination of hardware and software that produces noise or surface **artefacts** with feedate as a factor. This is the case for the...
i'm using flow of ~90% most of the time, which i think means my slicer is instructing the printer to use 90% of what would be expected. when using michael's...
I would like to see a note on the Slicer Flow Calibration page to have people take note of the accuracy of their measuring tools, as this is a significant...
Some of the text on the site does not contrast well against its background on the site, which makes it difficult to read for users with some forms of visual...
The firmware on the ender series of printers sets a limit for acceleration and jerk. Values above these limits (default 500mm/s/s acceleration and 8 jerk on all axes) will be...
When I upload gcode from the Teaching Tech generator to Octoprint, I receive an error stating "No Slicer Settings". My printer is a Prusa Mk3s+ I'm unsure of the commands...
Hello. I've printed 3 temperature towers using different temperature profiles but there is always some loose extruded material hanging off the bridge in the 1st and 4th level. It looks...
thank you for your website and all the videos. i just tried to connect my ender 3 v2 via usb to my computer to use pronterface according to your guide....
