tankist-git-2

Here is a project [3.zip](https://github.com/ImpulseAdventure/GUIslice/files/9462015/3.zip) The target platform is tft_espi with ESP32 MCU

This works. Thank you for the quick response!

I installed a new version of GUIslice Builder and repeat steps to install new font: 1) Replaced builder_fonts.json by yours 2) Put ahronbd.ttf into GUIsliceBuilder\fonts\vlw\ directory 3) Put AharoniBold18.vlw into...

O, sorry, that was really my fault. But actually even when I choose the right platform the problem still remains for me...  I see 260 symbols only and still...

I tried your file but result is the same. I'm a bit confused. Both files (I will refer to them as "old" - what included in release and "new" -...

Thank you very much for the investigation. Well, I will use existing font and maybe find another one with cyrillic and try to convert it again.

I tried my two joysticks again with the new firmware. There are no changes since the last test: Super Nintendo joystick hangs the board, X-Box joystick do nothing. PS joystick...

You should understand Xbox controller is not my goal. It's expensive and hard-to-get controllers. It would be great if you add support for cheap SNES controllers.

There is the UART log. It doesn't differ too much from USB log. I see 2 fails in log: [openhasp_uart_log.txt](https://github.com/user-attachments/files/21203376/openhasp_uart_log.txt) 1) GPIO: Invalid pin 0 2) MSGR: File not found:...

1) My router is not TP-Link, my router is Huawei HG8245H-256M 2) What country settings should be changed? I didn't find any in the post you are suggested. The only...