TinyG

TinyG copied to clipboard

Dear sirs, I want to buy your TinyG board to move 5 motors. According with the board description, the board has 4 drivers but the firmware is 6-axis control. My...

XavierCuenca

lekkerkoken

feedrate override with cncjs

1

i think i might be missing something here, i'm running the latest firmware on a tinyG v8 (Edge-449.01) and the lastest cncjs 1.9.22. with JSON enabled {sso:n} is not recognized,...

kbex1

TinyG hard alarms and reports this error: {er:{fb:440.21,st:31,msg:"Move time is NAN"}} on the last line of this G code snippet: ``` G1 X52.2955 Y48.9013 F60.68 M400 M114 M201.3 X38884 Y48990...

tonyluken

Hi! I'm planning to build my own 6dof robotics arm. I have bought all the AC servos and now I want to control them in the best manner. I did...

atlesg

G28.2 move starts, stops, and then continues

1

When I run the homing command the axis moves ~5cm pauses and then resumes the motion. If I click the limit switch between when it first starts moving and initially...

natd89

Hi: I am getting started using an rebuild shaepoko 2. Using ugs the spindle starts spinning and then stops. Any advise? Thanks

urbanmies

M115 code unsupported

1

A TinyG board with firmware build 440.20 and firmware version 0.97 reportes `err: M code unsupported: M115` when I send this code using a terminal. Same for M114. These M...

fxrb

Motors can run in the incorrect direction when the motor steps per turn parameter is set after the motor has already moved.

2

Motors can run in the incorrect direction when the motor steps per turn parameter is set after the motor has already moved. This can occur when motor parameter setup commands...

jay-sheldon-Nortech

homing command run for second time makes motors run in wrong direction

14

Hi, I have a raspberry pi that is connected to a tinyG for a cnc like machine. On the pi runs a node program that sends gcode directly to the...

brettdaman