TinyG

TinyG copied to clipboard

Canned cycles and subroutines

4

(From the synthetos TinyG forum at https://www.synthetos.com/topic/g83-canned-cycle-applicable-to-other-canned-cycles/) I’ve been thinking about how to program canned cycles, apparently while I was sleeping. I thought I would get this out there before...

aldenhart

Power management behaviors

2

I have reverse polarity set for my x and z axis (“$1po=1″, “$3po=1″), and always-on power management for all my motors (“$1pm=0″, “$2pm=0″, “$3pm=0″). If I’m at (0,0,0) in mm...

aldenhart

Zero backoff occasionally not working

1

from TinyG Support Forum - 3/27/2013 When homing with the x-axis, it occasionally does not do the movement for Zero Backoff. It backs off the latch until it opens and...

aldenhart

Delay after spindle starts

1

Generally, Spindles take some accelerating time to reach the rpm desired, after sending M03 or M04 the controller starts immediately the next move even if the spindle does not reach...

sacidu93

Using TinyG in WPF Project

6

Hello, I have a big project where the motors are used to move the arms of goniospectrophotometer. And as I understood WPF causes some thread related problems, because TinyG driver,...

David-Vice

Is there any way to use these widely available/cheap mpg pendants with TinyG?

vanem

Hi, I don't know if I'm doing something wrong, I'm new on it. When I send these gcodes at once I see that the motor x stops when G1X10F600 instruction...

XavierCuenca