Vasily Evseenko

@inindev I think the root of problem is invalid PCIe bridge setup, because device is not visible by `lspci` and after force pci bus rescan it show warning about invalid...

@MuratovAS Thanks! P.S. I've seen your portfolio - could you advice dc-dc for powering such wifi cards? Most of powerful 8812au and 8812eu cards consume > 3A in pulse when...

@MuratovAS Thanks! I had very bad experience with this dc-dc:  It dies with smoke when connected to 24V and connection is unreliable: https://t.me/wfb_ng/4457/11336

@MuratovAS Do you have any idea why glitching of input voltage can lead to dc-dc burnout? It is IC design flaw or bad schematics? All three dc-dc in my test...

@MuratovAS The main problem is that most of wfb-ng users are hobby users and unable to make custom PCB design themself. Most of ready to buy dc-dc from aliexpress has...

It seems this channel is blocked by your CRDA rules. Run: 1. `iw reg get` 2. `iw phy`

This is very strange - it should works, but please run the following commands: 1. `sudo ethtool -i wlan0` 2. `sudo iw dev` 3. `sudo iw dev wlan1 set channel...

if command (3) will not report an error but `iw dev` afterwards don't show 161 then it is normal - 8812eu driver doesn't report current channel right

@aepkolol ``` phy#0 Interface wlan0 ifindex 7 wdev 0x1 addr 78:22:88:19:2a:63 type managed ``` it should be in monitor mode

`Device or resource busy (-16)` check that no other processes (wpa_supplicant, dhclient, etc) use this card.