stefandz

Sorry to jump in on an old issue here chaps, but this seems the right place to put this. @rkistner and @toddtreece - I work for Bare Conductive and contributed...

Cool, thanks @rkistner - the only necessary changes will be removing Touch Board support (to avoid confusion). I'll submit these as a pull request once we have our end tied...

Thanks for letting us know, @NicoHood - do you happen to know if 1.6.6 has a solid release date yet?

I can report that [#117 ](https://github.com/arduino/arduino-builder/pull/117) fixes this on my Arduino 1.6.7 setup - I tested binaries provided by @facchinm.

Not trying to necromance a dead thread here, but I have the same issue as @lildutchie99 and @TimboInSpace where double-loading the driver is required. Build is on Raspbian Jessie, Rpi2...

Try running ``` modprobe configs ``` before ``` gzip -dc /proc/config.gz > .config ``` Also, ensure that your Kinect is plugged in before running ``` make load ``` later on....

OK - I got nothing - that worked for me previously!

Hi. Thanks for your extended comment and ideas. I understand how the HUB75 interface works - however, putting aside all of the pros and cons of using a Raspberry Pi,...