steevemadison

yes A2 should be PC2

this what lcd_id gave me -Sketch compiled for Arduino UNO: Read Registers on MCUFRIEND UNO shield controllers either read as single 16-bit e.g. the ID is at readReg(0) or as...

the core is from roger clark as generic stm32f103rb , setting 128k flash , 20k sram the #define for the post above was : #define LCD_RST PB7 #define LCD_CS PC3...

thank's for your time , i went back to my initial setup , TFT is mount in the coocox header , no wire . define my pinout like this in...

thank you , i have tried it , upload the graphictest to my coocox , open the serial and i get : Serial took 0ms to start ID = 0x9325...

the matrix board is cjmcu-8*8 (6 pins ws2812 led) top left din , +5 , gnd (depending on how you hold it in your hand) i took my multimeter to...