stagadet

I don't know if it is better to use GET or POST to modify parameters in this case. The official Daikin app that I tested uses GET, while I think...

Thank you for the info. I'll try to install an android application and I'll let you know what happens. A

Hi, I managed to sniff packets from the daikin application (I used tPacketCapture that works without rooting, creating a vpn to sniff packets). I found a couple of things: 1)...

Hi, the hardware/firmware I'm using is: ModelName: Daikin FTX ModelID: FTXJ50MW WiFiControllerID: BRP069A41 Software version: 2.6.0 I hope this is exhaustive enough, since I don't know where to find the...

> Seems that they are working except for /aircon/set_special_mode sets. They are returning > > ret=PARAM NG,adv= or ret=ADV NG,adv= > It seems that you have the newer model. Just...

@fcattaneo2 Hi, I don't think there is a request to get the instantaneous power of the device. As far as I know all the requests are the same that are...

@yelo3 Hi, I didn't noticed this before. Anyway, now that I'm not using the unit, I see that I have .1kWh consumption every 3/4 days. It may be the stand-by...

@chaicka I made a pull request with the commands I found sniffing the traffic with my configuration. If you can confirm that they work with your configuration (you can use...

@zerr0s the special modes seem to report "ret=PARAM NG" while the unit is OFF, even if the feature is supported. Are you sure the special modes are supported on your...

I can confirm too. (Also power consumption is ok for me). @ael-code maybe it is possible to add v3.3.1 to the tested hardware on readme.md?