Pekka Piippo

Ok, apparently different firmwares handle this differently. Hw config setting is probably the best option for this, should be easy to implement

Committed experimental code to temp_id branch, not tested.

Ok great, I'll merge this to master. Did you check the g-code for 3 extruders print? Was just wondering if S3D had used proper temp id assignments...

Hmm, previous comment missing... anyways, I added this to master, had apparently forgotten to merge it

I'll see what I can do. Don't have time to work on this any time soon, though.

Hmm seems strange. Do you have z-hop (retraction lift) enabled? I haven't tried filaswitch without z-hop so this might be the reason. If possible, send me the original gcode file...

@maxstier, @FireBookDuo: I haven't checked the code yet, but I'm quite certain that when z-hop is either 0 or off, the layer after printing the tower won't work properly. I'll...

Latest master has fixes that should help with these problems. Please test it and report back

Ok, I'll have do a test print because I can't see the problem just by looking at the g-code or the S3D preview

Printing and only problem I can think of is that at the bottom, the 0.5mm raft layers cause the tower to be lower that the actual model, but after a...