Hermes-Lite2

Hermes-Lite2 copied to clipboard

Enhance Remote CW Functionality

5

See: https://groups.google.com/d/msg/hermes-lite/_BAiRyqGvJk/GZsyNuuNBAAJ

softerhardware

Simulation of DSP Chain

2

Bugs may have crept into the DSP chain. Simulation of the DSP blocks at max,min,normal values as well as reponse extraction would be good.

softerhardware

Enable half/full duplex dynamic switching

2

As discussed [here](https://groups.google.com/d/msg/hermes-lite/iP45Tecrlsg/ZneH7Ef8AwAJ), it would be nice to be able to switch to half duplex to (hopefully) improve RX performances and to full duplex when needed (Puresignal, etc.).

in3otd

Combine I2C Controllers to Save Resources

1

softerhardware

Clean all Warnings and Bogus Timing Violations

1

softerhardware

Add new Wide Spectrum Mode to send RX packets: * Run like normal * Command to set Versa frequency * Stop * Turn on new RX packet mode Should work...

softerhardware

Q1 burns instead of F1 tripping when there is a short

1

softerhardware

Make sure VNA still works

softerhardware

EER/ET Support

1

Claudio has added basic support. This needs to be enabled and tested. https://www.ece.ucsb.edu/Faculty/rodwell/Classes/ece218c/notes/Lecture14_Envelope%20Tracking.pdf

softerhardware

If I use the TUNE function (e.g. in Thetis), the UART of the HL2 sends out tons of DATA with the actual frequency. If I use MOX it is not...

dl1bz