slowake

I tested it. In all cases no data on transmitter. File names are selfexplaining [HOTT,voltage activated,transmitter OFF.txt](https://github.com/user-attachments/files/20638200/HOTT.voltage.activated.transmitter.OFF.txt) [HOTT,voltage activated,transmitter ON.txt](https://github.com/user-attachments/files/20638201/HOTT.voltage.activated.transmitter.ON.txt) [Serial monitor,input1,19200,1,,none,1,string.txt](https://github.com/user-attachments/files/20638202/Serial.monitor.input1.19200.1.none.1.string.txt) [Serial monitor,input5,19200,1,,none,1,string.txt](https://github.com/user-attachments/files/20638204/Serial.monitor.input5.19200.1.none.1.string.txt) [Serial monitor,input6,19200,1,,none,1,string.txt](https://github.com/user-attachments/files/20638203/Serial.monitor.input6.19200.1.none.1.string.txt)

Sorry for my late answer, your mail were in my spam. Yes, HOTT packets are presented, but after some secods they disappears. 1. I have resistor 120 ohm between GPIO0...

Latest firmware from github. Vario and receiver connected together to GPIO5 Log1: Serial monitor, GPIO5, 19200, 1, none, String Log2: Serial monitor, GPIO5, 19200, 1, none, HEX On transmitter is...

Latest firmware loaded. Vario sensor enabled, but not connected. HOTT protocol. GPIO0 and 1. HOTT messages at the end of log disappear. Interesting - after i reconnect the MSRC, vario...

Sorry, i have not selected sensor type. HOTT messages are presented and they are equal, as you posted here. After some seconds they disappear. On transmitter no vario sensor [MSRC_debug...

HOTT and Vario MS5611 activated (not connected). Pullup resistor 1K to 3,3V (HOTT receivers input level is max 3,3V). Transmitter ON, MSRC ON, MSRC_link Connect, enable log. HOTT messages disappear...

Now it is working with some exceptions. Configuration is here: On transmitter are detected three modules: Vario, Electr. Air and GP. Thats OK. - Vario MS-5611 is working OK. -...

Sorry, NTC temperature is working too. Bad connections