Lan Hu issues

Repositories
Issues
Comments

Results 2 issues of


                                            Lan Hu

Require restart of klipper software after power on

After receiving print job via cura, PSU turns on successfully. Because of this the micro controller gets power and interferes with klipper via rpi4. Require restart of klipper, however adding...

Require esp32 pin high when RX is enabled/TX is enabled and low when disabled

### Describe you new feature you'd like I bought[ E07-433M20S](https://www.google.com/url?sa=t&source=web&rct=j&opi=89978449&url=https://www.cdebyte.com/products/E07-433M20S&ved=2ahUKEwjt9p-b4tqMAxXozgIHHWRpBlgQFnoECAoQAQ&usg=AOvVaw3FpEy7Pkm-CPmgWHzKC4kA) with CC1101 chip inside and a PA+LNA. However to properly use this, I need to set the TX_enable pin high...