sheikoner
sheikoner
> > I have the exact same issue, and currently I have also disabled `reduce infill retractions`, but that only helps the printer avoid infill collisions. The main area I'm...
I did it on the repo, and the costumer support. Just adding some info because the op suggested me. El mar, 23 ene 2024, 14:55, CCS86 ***@***.***> escribió: > You...
You have to post in the Bambu slicer thread, they are just volunteers developers from open source software that is not official of the brand. El mar, 23 ene 2024,...
> Try resetting your Z offset to 0 if you've changed it in OrcaSlicer. I had a similar issue and that seemed to do the trick for me at least....