shawn

I’m also having trouble. I’m not getting anything from serial when using gnd rx and tx. Do I need to set parameters in make menuconfig. I disabled usb and went...


i have updated my configs. I now get this error after i start a print and z tilt adjust. console says my probe is already triggered. probe goes to x...

After g28 my probe stows then picks back out of dock and does z tilt adjust. Once that is done it stows the deploys again to mesh. Would I still...

I dont know what i am doing wrong. I have changed configs to no avail. using batch mode in cura yields no result but works. i am trying to use...