Shai Perednik

could you send a message based on a comment in the gcode? I know cura writes LAYER=2 to the gcode output

I agree with mitchpod and would love to see this pull merged if that system status tile is removed

@Kulitorum I have a rumba and BLtouch as well. Thank you for sharing! Have you gotten this up and running? Could you share an updated config file? Thank you!

@archgalileu. my config is at https://1drv.ms/u/s!ApzOdVx9w7haifw1Tc8G1fmHvbuZ6Q and it works. at the moment I home to zmax and then g32 s2 to calculate the z height. in the next couple of...

@archgalileu I will be not yet. I home to zmax and use the bltouch to calculate the z height. that's repetier's standard. recently in the dev branch there's been alot...

I got it to work only after countless 10s of hours. I don't know if it was worth the headache. I don't think it's repetier's fault that the bltouch doesn't...

under serial connection > Firmware & Protocal > Protocal Fine Tuning > Blocked Commands add M110. Alternatively, M110 could be added to repetier fw to have the same behaviour like...

PRs are accepted by the maintainers. Seems like we need to wait for them to catch up or help out. There's likely a ton of merge conflicts.

I've cleaned up the code that was part of pr #198 and resubmitted here, closing the original PR

@pashpashpash ty for the reply. Would it be plausible to switch to https://pypi.org/project/poppler-utils/ to simplify deployment? This would help with containerizing the app.