sfromis
sfromis
Configure gpios to match your hardware. Maybe simply try removing the Button config from the template.
Again, do config to match your hardware. Using gpio2 for TX and gpio15 for rx is highly unusual. Are you quite sure about that? Do you have a good source...
What I meant was that when you tried to modify the template you posted, you should not just select completely different gpios for tx/rx (sure, in the TCP variant, of...
Are you expecting Tasmota to provide Zigbee at the same time as connecting to ZHA. That's not how it works. It is either-or.
You did not answer my question about your expectations. But if you **only** want ZHA operation (without Tasmota Z2T active), you need to configure ZHA appropriately for it. If you...
If you want to use Zigbee2MQTT (Z2M) or ZHA, you cannot also use the devices locally. When you config for TCP, there is no longer anything Zigbee done in Tasmota,...
Well, what you need is what you already posted about doing, modify the config of TX/RX pins to be the TCP variant, just make sure to use the right gpios....
Hard to guess, as you are not telling what you did to get there, or what's in the log.
To update the Zigbee chip firmware, you need to use a template for Z2T mode, instead of one with TCP for control via ZHA/Z2M. It is the template given on...
Then you are not doing a valid attempt to update the firmware. What you posted first looked ok, but not the file names you posted now. You can find the...