AqualinkD
AqualinkD copied to clipboard
sfeakes
Daemon to control Jandy Aqualink RS pool equipment from any home automation hub (Alexa, Homekit & Siri, Home Assistant, smartthings, domoticz etc) or web browser.
seems to use air temp for pool temps ``` 14:25:55.260 Info: iAQ Touch: Page: HOME | 0x01 14:25:55.260 Info: iAQ Touch: Home Status page 00| -- 14:25:55.260 Info: iAQ Touch:...
I think the menu page is not fixed contrary to the statement here https://github.com/sfeakes/AqualinkD/blob/40e2c38ce0be87246248ae30bb34fd60f6edbf53/iaqtouch_aq_programmer.c#L37 Sends Button 04 (keycode 0x14) but seems to get stuck at menu page. Probably needs to...
Aqualinkd is running well. With the Aqualinkd Management Console, I have noticed an increase in checksum errors and bad packets. It does not seem to interfere with the operation. Under...
I am running a pda-ps8 combo with rev 7.1.0. Running current development version 2.4.1 dev 0.1. My system has the pda-ps8, Jandy 18 channel RF receiver, IAquaLink, and a Jandy...
EDIT 2: Using the Aqualink Touch protocol `extended_device_id=0x31` works better - power / rpm goes to zero when the pump is turned off, shows higher power when priming, then the...
I'm using OpenHAB over MQTT to send commands and read status from AqualinkD. Overall, I have to say the service is amazing, and incredibly adaptive and configurable to all of...
Intro: I followed the steps in the Wiki to install 1. required dependencies, 2. cloned the repo, 3. without make I'm doing an install of the AqualinkD by running `sudo...
I have everything wired and setup. I can access the control panel, but the button presses are not doing anything. I am attempting to use the serial logger to get...
I have a Jandy RS board (Yg / 4.3.13 firmware), that was the upgrade for the iAqualink 3 (since I previously had a PPD PDA chip). I also have a...
Hi So I have two issues, first being I have button 08 assigned to "bubblers" in my aqualinkd.conf which looks like it's actually assigned to the Solar button which I...
